yes, that's close to what I got from his post- unfortunately, I don't have an answer. -----Original Message----- From: Hans Shin [mailto:[log in to unmask]] Sent: Thursday, December 21, 2000 12:38 PM To: [log in to unmask] Subject: [TN] RE: [TN] PRESIÓN DE VACÍO I think this is what Fernando may have written: "need to know, what is the recommended value of pressure mold/casting, in an insulated system...if crystal is used/I would be obliged to use this information. We are working on a mold approximately 60 cm/Hg. Thank you." I hope I translated it right. Hans Shin Pacific Testing Laboratories, Inc. http://www.pacifictesting.com/ -----Original Message----- From: Angel Pulido [SMTP:[log in to unmask]] Sent: Thursday, December 21, 2000 9:23 AM To: [log in to unmask] Subject: [TN] RE: [TN] PRESIÓN DE VACÍO English please, we do not understand that... thanks. -----Original Message----- From: Fernando Gómez [mailto:[log in to unmask]] Sent: Thursday, December 21, 2000 11:06 AM To: [log in to unmask] Subject: [TN] PRESIÓN DE VACÍO NECESITARÍA SABER, CUAL ES EL VALOR RECOMENDADO DE PRESIÓN DE VACÍO, EN UN SISTEMA DE INSOLADO (ORC, DUPONT etc.), SI SE USA CRISTAL/CRISTAL. AGRADECERÍA ESTA INFORMACIÓN. NOSOTROS ESTAMOS TRABAJANDO A UN VALOR APROXIMADO DE 60 cm/Hg. GRACIAS. ---------------------------------------------------------------------------- ----- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------- ----- --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------