I'm currently experiencing poor wetting on chips with Palladium finish, and was about to post a request for advise, perhaps the profile control limits are to be tighter than with Ni/Sn finishes. Can anybody help? Are there any special procedures to achieve good wetting on these lead finishes? > ---------- > From: Lisa Anderson[SMTP:[log in to unmask]] > Sent: Tuesday, November 28, 2000 11:29 AM > To: [log in to unmask] > Subject: [TN] 95Sn/5Pb Tinned leads > > Question to the forum: > > Has anyone experienced problems regarding solderability of component > leads tinned with 95Sn/5Pb solder? > > Many thanks for your input, > > lba > > -------------------------------------------------------------------------- > ------- > Technet Mail List provided as a free service by IPC using LISTSERV 1.8d > To unsubscribe, send a message to [log in to unmask] with following text in > the BODY (NOT the subject field): SIGNOFF Technet > Search previous postings at: www.ipc.org > On-Line Resources & Databases > > E-mail Archives > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for > additional > information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 > ext.5315 > -------------------------------------------------------------------------- > ------- > --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------