Hi Ken, It has a lot of consideration. Like, number of holes. size of the board. how many layer of the brd. what type of laminate , materials of the board. what type of finishing. etc... Thanks & Best Rdgs Adeline Ko > -----Original Message----- > From: Ken Patel [SMTP:[log in to unmask]] > Sent: Sunday, October 15, 2000 2:48 AM > To: [log in to unmask] > Subject: [TN] PCB Layout quotation > > Layout folks, > I have a friend who asked how quotation is being done for PCB. Is it the > number nets, holes, parts... > > re, > ken patel > > --------------------------------------------------------------------------------- > TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d > To unsubscribe, send a message to [log in to unmask] with following text in > the BODY (NOT the subject field): SIGNOFF TECHNET > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional > information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 > --------------------------------------------------------------------------------- --------------------------------------------------------------------------------- TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF TECHNET Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------