This convert tool is very handy. Check it out. < At 12:09 PM 10/23/2000 -0500, you wrote: >I am looking for the true mm to inch conversion. Webster defines a mm as >being .0394 inches but the conversions I see on drawings do not agree with >this. Where can I find the definitive conversion formula? Any ideas? >TANX! > >> Tony G. Huffman >> PC Board Layout Specialist >> Hunter Engineering Company >> 11250 Hunter Drive >> Bridgeton, Mo. 63044 >> [log in to unmask] >> (314)731-0000 ext.330 >> (314)731-9932 FAX >> http://www.hunter.com >> >> > >--------------------------------------------------------------------------------- >DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d >To unsubscribe, send a message to [log in to unmask] with following text in >the BODY (NOT the subject field): SIGNOFF DesignerCouncil. >Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives >Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional >information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 >--------------------------------------------------------------------------------- > > --------------------------------------------------------------------------------- DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF DesignerCouncil. Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------