Guys Does anyone out there know what the IPC or Industry standard is for press fit Edge Connector, in terms of what the spec should be from the top of the board to the bottom of the conector, along with how much tilt is allowed ? Also is there a IPC document which highlights this ? Thank You in advance. Sal. --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------