Hi- I am looking for a passivation material or solder resist that is screen= printable. This material will be used as the only means of environment= al protection for an electronic component. It is very desirable that the material be able to withstand temperatures of 400=B0C and be somewhat e= asy to process. I would also like a one part material that does not have a lo= ng cure time. There may be no perfect material, but if you have any ideas= , comments, or suggestions, please contact me. -PS- Our products must pass a 2000 hour 85/85 test. Thank You, Dennis Fall Process Engineering Supervisor Thin Film Technology Corporation North Mankato, MN 56003-1702 Email: [log in to unmask] Phone: 507-625-8445 (dial ext. 27 and have me paged or ext. 17 for gene= ral voicemail) Fax: 507-386-9269= ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################