Hi All,
     Here's the scenario: We're making a small board with a 133 pin PGA.
Many vias between pads (Vias are 12 mil hole/ 25 mil pad). Customer wants to
avoid shorts under the PGA during assembly and is requesting that we plug
via holes and cover the vias on the part side.  What's the best way to do
this.  (We've got LPI and SR1000 to work with).


Thanks,
Mark Hargreaves
EMDS

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################