For the thermosoldering, the pads need to be coated with tin. In our case
the coating must be as thin as possible.
I was wondering if this step could be done by wave soldering.
Does anybody know the average thickness of tin on the pads of a Ni/Au
finishing board (without components) after wave soldering ?

Thanks for helping,

Walter.

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################