[log in to unmask]" rel=File-List>
Barry Gallegos,
 
Check out a McMaster Carr catalog. The "Air Pucks" are called Air Bearing Movers (air sleds). I've used them in a previous life. They are very good in moving heavy equipment. But there are a few caveats that you should be aware of.
1. You will need a constant air supply while moving the equipment from one location to another.
 
2. The floor must be reasonable smooth. If the floor is not smooth, it is possible that the height of the air cushion needed to raise the equipment will not be constant and you will get stuck (Trust me. It happened to me while moving some very large test equipment though a hallway. We go stuck at an expansion joint.).
 
3. You still would have to get the equipment on the air sled. This means lifting it onto the air sled. You should contact your mil-rights (please forgive my spelling) about this. You may also need several units, depending upon the size and weight of the hardware to be moved.
 
4. While 1 person can move the hardware, I recommend that a team perform this operation. Once you get the hardware on the sled, once in motion, it could be very hard to stop because of the lack of friction between the hardware and the ground. Remember, you are moving rather expensive equipment on a cushion of air which could measure anywhere up to 2 inches.
Good Luck.
 
Lee Whiteman
Senior Manufacturing Engineer
ACI / EMPF
Telephone: (610) 362-1200; Ext. 208
FAX: (610) 362-1290
E-Mail: [log in to unmask]
 
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Barry Gallegos
Sent: Monday, July 10, 2000 10:02 AM
To: [log in to unmask]
Subject: [TN] Equipment moving.
Importance: High

Good mourning TechNet.

 

I have been tasked with finding a way to move my Pick and Place machines, ovens and Wave solder machines around our manufacturing facility floor.

I have heard that there is something called an Air Puck that will allow a single person to move a large object with just his one itty-bitty little finger. If this is true, where can I find them?

 

 

Barry Gallegos

Process wana be.

208-377-1557 phone

[log in to unmask]