To: PCB guys and gals... Plane Capacitors... it was the topic for discussion at PCB West in Santa Clara... have any of you had experience with manufacturing boards with a 4 mil gap between the gnd plane and the signal layer? What are the challenges you see... and did you realize any benefits from the exercise? Bill Brooks Senior PCB Designer - <mailto:[log in to unmask]> [log in to unmask] Zoneworx, Inc. 40925 County Center Drive, STE 200 Temecula, CA 92591 <http://www.zoneworx.com/> http://www.zoneworx.com Tel: (909) 296-1226 x 1037 Co-Director / Education Officer / Webmaster for the San Diego Chapter of the IPC Designers Council <http://www.ipc.org/SanDiego/index.html> http://www.ipc.org/SanDiego/index.html Thanks, Bill Brooks Senior PCB Designer - [log in to unmask] <mailto:[log in to unmask]> Co-Director / Education Officer / Webmaster for the San Diego Chapter of the IPC Designers Council http://www.ipc.org/SanDiego/index.html <http://www.ipc.org/SanDiego/index.html> Expand Your Domain! _____ Zoneworx, Inc. 40925 County Center Dr., Suite 200 Temecula, CA 92591-6037 Ph: 909.296.1226 (x1037) Fx: 909.296.1227 Visit us on the Web: zoneworx.com <http://www.zoneworx.com> ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################