'netters:

I've recently completed a study to replace our old, vintage mid 80's,
wavesolder machine and in-line cleaner with new equipment. I've made a
selection but I'd like to get a cross section snap shot from you folks that
answers the question...

If given a low to medium volume, high mix, mixed technology, printed circuit
board assemly line that will use water soluble flux... (Assume for the
moment that money is no object.)

What wavesolder and in-line cleaning system would you recommend?

Not looking for dissertations here but rather a selection and a sentence or
two.

My intent here is to make sure I haven't overlooked something.

Disclaimer: Answers given will not be construed as advertisement subject to
severe castigation from anyone on this forum.

Thanks to all who can respond.

Bill Kasprzak
Moog Inc.

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################