Hi Mary, Give Kwickfit a try: http://www.micromeg.com I've used it a few times to determine the best panelization I could expect to get from a board size. Try it for free, then decide if you want a full blown registered version. Good luck. Mitch ---------Included Message---------- > Date: Tue, 18 Jul 2000 08:56:49 -0500 > From: "Mary Deichmann" <[log in to unmask]> > Reply-To: "DesignerCouncil E-Mail Forum." <[log in to unmask]>, <[log in to unmask]> > To: <[log in to unmask]> > Subject: [DC] Design Panelization > > I would like to ask the audience. What is the software most used in the > fabrication or design industry for panelizing designs? We are looking to make > a > change from our current UNIX software to an NT based software. Any help would > be > greatly appreciated. > > All replies can come directly to me if this is not allowed on this forum. > > Thank you, > Mary Deichmann > Design Engineer > Electronic Products Division > 3M Austin Center > 6801 RiverPlace Blvd. > Austin, Texas 78726-9000 > ---------End of Included Message---------- _____________________________________________________________ Tired of limited space on Yahoo and Hotmail? Free 100 Meg email account available at http://www.dacafe.com