HI all,
I'm looking for some feedback as to the effectiveness of
reflective AOI systems for use on etched lines that finish with below a .004
top. I have had mixed results in this area. When left with a 4 mil top (
or less ) on the circuit after etch, we tend to see a lot of prude defects
related to stains and other cosmetic blemishes. This leads to excessive amounts
of verification which we all know increases the potential of escape.
We are currently looking a purchasing a new AOI system We are
debating between Laser or reflective. So, based on this perhaps those
of you that use AOI units could respond to the following questions. Due to
the nature of the request, you may wish to send the response to me directly.
Please note: I am not looking for response from AOI suppliers.
Users only.
1. Would you recommend laser or reflective?
2. Do you have laser or reflective?
3. How many false callouts are you having to deal
with on fine
lines?
4. Whose equipment would you recommend?
5. How much down time are you seeing?
All responses will be greatly appreciated.
Thanks,
Ed Cosper
I would appreciate some feedback