Mark- I am not familiar with Cadstar The best thing to do is contact Cadstar direct.....Here is information found via their web page. I had problems finding any Telephone numbers or email on their web site....this information was found in a press release. Mark Ashton, Zuken Ltd., 1500 Aztec West, Almondsbury, Bristol, BS32 4RF, UK Tel: +44 1454 207800 Fax: +44 1454 207803 E-mail: [log in to unmask] -----Original Message----- From: TechNet [mailto:[log in to unmask]]On Behalf Of Mark Holmes Sent: Thursday, June 29, 2000 6:08 AM To: [log in to unmask] Subject: [TN] CADSTAR Placement file Hi all, Our manufacturing plant has a pick and place file which I believe was created using Cadstar. The rotations given for the parts are 0,1,2 and 3. My questions are: what angles to these numbers correspond to, and is the rotation clockwise or anti-clock wise? They don't have a bare board to hand at the moment, so any advice would be most appreciated. Best regards, Mark. Mark Holmes PCB Designer Helvar Merca Ltd. Hawley Mill, Hawley Road, Dartford Kent. DA2 7SY Tel: 01322 22 22 11 Fax: 01322 282 286 mailto:[log in to unmask] http://www.helvar.com ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ############################################################## ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################