Technetters,

We are currently using a diamond cross-hatching pattern for plating thieving
and are experiencing the following problems when using this on 3 - 5 oz
finished
panels.
     - excessive entrapment / dragout of solutions (etchant,tin strip etc.)
     - the height of the finished thieving also aggressively attacks
       the composite brushes in our pre-mask scrubber.

Any ideas on what different configuration \ design for plating thieving on the
panel waste areas  may act best in helping minimize these occurrences while
still acting as a good plating thief.

Thank You

Brett Austin
Nationwide Circuits, Inc
[log in to unmask]

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################