Can anyone shine some light on picking shorts on boards for me? The shorts are located on the outer layer of the board. It is copper sreading between traces causing a short, is it ok to pick this excess copper with a normal pic knife?  Is there a spec for this procedure in IPC?

Thanks

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################