Hi,

Since I`m new at this...

I would require some informations concerning the padstacks on multi-layer
board.
what should be the dimensions of the pads of a through hole component, on
the inner layers compared to the ones on the external layers of the board?
Should they be bigger or smaller (by how much?) or the same size?

I belive smaller but I'm not sure.

Thank You.

Denis Seguin
CAD Department.
P A R A D O X
S E C U R I T Y        S Y S T E M S
Email: [log in to unmask]

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################