Hi, We have used a Caviderm system in incoming inspection to measure the plating thickness in PTH. Maybe you can find a local dealer for it. B.R. Jarmo > -----Original Message----- > From: [log in to unmask] [SMTP:[log in to unmask]] > Sent: 23. toukokuuta 2000 11:10 > To: [log in to unmask] > Subject: [TN] microhm resistance meter with standard four*probe > > TechNetters; > Does anybody know where can purchase the microhm resistance meter with > standard four*probe technique that mentioned in IPC-TM-650 2.2.13.1 " > Thickness, Plating in Holes Microhm Method" ? > Any feedback at all would be greatly appreciated. > Best Regards > > > Jesse Hung > Customer Quality Engineer > Quality Assurance Department > Tel:886-3-3231111 ext: 5361 > Fax:886-3-3235874 > email address: " [log in to unmask]" <mailto:[log in to unmask]> > > > << File: Ivy.gif >> ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################