Technetters Has anyone had any experience - either good or bad, with solderpasting and reflowing of RIST 2.5 (or smilar) edge connectors? The reason I ask is that our designers have designed a single sided PCB for Reflow soldering. From a cost point of view they would prefer an OSP finish to HASL therefore we must provide a soldered finish to the edge connectors with solderpaste. Before I begin to organise trials I would appreciate hearing from any of you who may have un/successfully gone down this path. best regards Thornton White ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################