Ken - Can you use an edge clip? Or, if you have an unused pin on a DIP, use that? There may be other "creative" options, but it would depend on your layout among other factors. Food for thought, anyways. Ed Valentine Electronics Manufacturing Solutions 8612 Mourning Dove Road, Raleigh, NC 27615 Phone: (919) 270-5145, Fax: (919) 847-9971 Email: [log in to unmask] Website: http://www.ems-consulting.com ----- Original Message ----- From: Ken Patel <[log in to unmask]> To: <[log in to unmask]> Sent: Tuesday, March 07, 2000 7:29 PM Subject: [TN] Running of Jumper wire... > Guys, > Does IPC call out running a jumper wire at the edge to take on the other > side? I personally think no. We do not have holes in the board to run it on > the other side. > > Does anyone has any inputs on the matter? > > re, > Ken Patel > ______________________________________________________ > Ken Patel Phone: (408) 490-6804 > 1708 McCarthy Blvd. Fax: (408) 490-6859 > Milpitas, CA 95035 Beeper: (888) 769-1808 > > ############################################################## > TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c > ############################################################## > To subscribe/unsubscribe, send a message to [log in to unmask] with following text in > the body: > To subscribe: SUBSCRIBE TECHNET <your full name> > To unsubscribe: SIGNOFF TECHNET > ############################################################## > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional > information. > If you need assistance - contact Keach Sasamori at [log in to unmask] or > 847-509-9700 ext.5315 > ############################################################## ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################