Hi All, Is there anyone out there running Enthone's DMS-E direct metalization process? If so, what kind of yields are you getting? Any problems with small holes (.008" - .016")? Do you have horizontal conveyorized process or vertical and if horizontal what equipment are you using? Does your equipment have triple rinsing? Do you have a micro etch between the desmear and DMS-E part of the line? Is your desmear vertical or horizontal? Best Regards, Scott ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################