Okay here's one for you,

I can't find it in the standards, but I am sure that there is one.  What is
the specification for the temperature and humidity requirements when we are
dimensionally inspecting circuit boards?  What document is this located in
and where in that document is it?

I am looking for this information to add to our notes as we have a couple of
holes on a circuit board that are +/- 0.001 (Don't shoot me!  I didn't
design it!) and with holes that tight I know I will probably need a note to
cover this.

Thanks


Mark Ross
Project Engineer
Donnelly Electronics

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################