Unless you are concerned abour the Delta T of ceramic caps you should run
the solder temp at 280-500 degres F.  Yes, a low solder temperature will
result in skips and insufficient hole fill.

Ride The Wave,
Ken Kirby
Speedline Technologies



 (Embedded
 image moved   Ivan Barrios <[log in to unmask]>
 to file:      01/28/2000 02:21 PM
 pic30074.pcx)




To:   [log in to unmask]
cc:    (bcc: Kenneth Kirby/ElectrovertUS/Cookson)
Subject:  [TN] Wave solder pot twemperature




Is there a reccomendation on how hot the wave solder temperature should run
at
the pot/ We run at 450F and we are seeing some no solder on BSMT's is there
an
correlation in temperature vs no solders?
Thanks for any responses
Ivan Barrios

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################