We design for ICT testing, but need to use flying probe until the board is stable enough to go to ICT. Our board loading contractor is having difficulty probing our 0.032" (0.8mm) test via's with their flying probe tester. They want us to go to 0.040" (1.0mm) pads on new designs. Any comments? ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################