Check out http://www.autogroup.com/designguideb/
<http://www.autogroup.com/designguideb/>

-----Original Message-----
From: Clayton Gardner [mailto:[log in to unmask]]
Sent: Tuesday, November 30, 1999 10:17 PM
To: [log in to unmask]
Subject: [TN] Wave Solder Pallet Masking Guidelines


Hi All

Hoping someone out there can offer me advise or direct me to an information
source on wave solder pallets for mask secondary side surface mount
components (which have been Reflow soldered).

In particular, any design guidelines for clearances between the lead
requiring soldering and the pallet edge, to avoid shadowing and soldering
defects.

Any information or experiences will be appreciated.

Thanks for your time

Clayton Gardner
Engineering Manager

A.E.M.S
Keysborough VIC
AUSTRALIA
WEB:  www.aemspl.com.au <http://www.aemspl.com.au>

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################