Circuit can be 8 -10 mils from board edge, no
problems with the board shorting to any metal.

                        Phil Hennigan
                        904-739-4116 (voice)
                        904-739-4200 (fax)
                        [log in to unmask]


                                -----Original Message-----
                                From:   Ken Patel [SMTP:[log in to unmask]]
                                Sent:   Thursday, December 09, 1999 4:13 PM
                                To:     [log in to unmask]
                                Subject:        [TN] Edge Clearance for
power & ground planes

                                Guys,
                                How far my power & ground planes should be
away from the egge of the board?

                                re,
                                ken patel

______________________________________________________
                                Ken Patel                       Phone:
(408) 490-6804
                                1708 McCarthy Blvd.             Fax:
(408) 490-6859
                                Milpitas, CA 95035              Beeper:
(888) 769-1808


##############################################################
                                TechNet Mail List provided as a free service
by IPC using LISTSERV 1.8c

##############################################################
                                To subscribe/unsubscribe, send a message to
[log in to unmask] with following text in
                                the body:
                                To subscribe:   SUBSCRIBE TECHNET <your full
name>
                                To unsubscribe:   SIGNOFF TECHNET

##############################################################
                                Please visit IPC web site
(http://www.ipc.org/html/forum.htm) for additional
                                information.
                                If you need assistance - contact Gayatri
Sardeshpande at [log in to unmask] or
                                847-509-9700 ext.5365

##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################