Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 1 Dec 1999 15:31:39 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Ted,
Have you had the solder analyzed lately? If the copper content is running
high (greater then 0.035%), or other contamiants are present solderability
will suffer. Also you mention good coverage, but neglect to say solder
thickness. Anything less then 25-30 microinches is strictly copper tin
inter-metallic and will not solder very well, especially if any bake cycles
occur after HASL.
Call if you would like to discuss further.
Jim Kenny
Alpha-Dexter
603-759-4713
Ted Stern <[log in to unmask]> on 12/01/99 01:56:40 PM
Please respond to "TechNet E-Mail Forum." <[log in to unmask]>; Please respond
to Ted Stern <[log in to unmask]>
To: [log in to unmask]
cc: (bcc: Jim B Kenny/Electronic/Dexter)
Subject: [TN] Solerability after HAL
Dear Technetters:
I have a customer processing a double sided .040 panel with SMT pads on
both sides and limited through holes, which fails the plated through
solderability test after HAL. The process is as follows:
1. homemade sodium persulfate microetch with 2-3% Alpa Metal "Copper
Brite",
the immersion time is modified based upon the etch rate to achieve 30
microinch copper removal.
2. City water rinse, tripple cascading.
3. Warm air dry.
4. HAL Flux
5. Teledyne horizontal HAL, 3-6 seconds at 490 F.
6. 7-8 second delay on horizontal air-bed to a 120 F water rinse, then
dry.
After HAL the copper coverage and appearance is good, but upon solder
float testing, random pads will not accept solder. Additionally, after
solder float testing a small number of pads that did not accept solder
also appeared to pull back from the edge expsoing the underlying copper.
Any thoughts would be appreciated.
Regards,
Ted Stern
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|