Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 17 Dec 1999 14:30:53 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi James
We eat magnet wire by the ton.
Our factory in Mexico dips the ends in what we consider Hi-Temp solder, 450
C.
When we don't do that; which is 99% of the time we use an abrasive wheel.
Good Luck
-----Original Message-----
From: Terveen, James @ NARDAEAST
[mailto:[log in to unmask]]
Sent: Friday, December 17, 1999 9:16 PM
To: [log in to unmask]
Subject: [TN] STRIPPING ENAMEL COATED WIRE
We have until recently used stripex to remove the coating on
magnet wire
on very small hand wound coils. These coils are made of
usually .003
mil magnet wire wound around a .053 mandril. The problem
we are going
to run into in the near future is we can no longer get
stripex so we
need another way to strip the insulation off the wire. If
anyone has a
process or any idea's they would be greatly appreciated.
##############################################################
TechNet Mail List provided as a free service by IPC using
LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask]
with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site
(http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at
[log in to unmask] or
847-509-9700 ext.5365
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|