Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 14 Dec 1999 14:22:00 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Julie,
I think what the problem might be is this. When laminating dry
film a small amount is squeezed into the hole. This can be
exascerbated if the holes aren't completely dry. The other part of the
problem if you are running your developer conveyor at the high end of
the speed. What this does is leave a ring of resist just inside the
hole below the knee. This of course does not plate up with either
copper or tin/lead. When the board is stripped the resist is removed
and there you have a ring of copper waiting to be etched.
Hope this helps.
Mike Doty
P.E. Hadco TCE
______________________________ Reply Separator _________________________________
Subject: [TN] Ring Voids
Author: Julie Dixon <[log in to unmask]> at smtplink-hadco
Date: 12/14/99 8:42 AM
Dear TechNet,
What would cause a perfect ring void just under the knee of the hole, with
the knee
intact? Drill, DML, Dry film, light scrub, Pre plate clean- acid cleaner & Na
Persulfate Etch 10-15 micro inches, Acid CU, Acid bright Tin, Mono DF strip,
Ammoniacal
Etch. Job specific to 1 part # all other product running along side is
perfect.
All material Std. .062 Fr-4 1/1. Longtime runner w/ no probs in past.
Thanks,
Julie Dixon
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text
in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|