Hi technet wizzes!
We're re-establishing our QC dept and I would
need to know what to look for in the solder
inspection departement. What kind of microscope
should I look for? According to the table in
IPC-A-610, I would need 10X mag. equipement, Is that
enough? Most of our board are surface mount, be we
do have some through hole board done.
We have a 6X from Vision Engineering (Mantis) and
it is not sufficient (from my point of view) to inspect
certain soldered smd chip.
Any suggestions???
JF
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################