Hi All You Sherlock Holmeses (sp?) out there,

I have a strange mystery which intermittently appears, so put on your
Sherlock Holmes' hat and grab Dr. Watson.

When we wave flow solder one particular board, during our cleaning process
(which can be moments afterwards), we might see tin and lead oxides
covering/surrounding the pins.  When we do see it, it's real bad.  DeOxIt
cleans it off well.  Any better corrosion removal suggestions out there?  My
ultimate goal is to prevent it (well duh).

We use Kester 186 and 186-18 RMA flux, it's a Kester 60/40 tin lead solder
in an old Hollis wave flow soldering machine.  We also use a latex solder
mask, how that might cause corrosion I don't know but there it is.  The only
remaining culprit might be very old (from Hollis) tinning oil, aka dross
inhibiting fluid.  The solder is tested by Kester, Option C, and are well
within MIL-STD-2000 & J-STD-001 specs for the 12 contaminants they check.
The boards are fluxed by brushing it on with a camel hair brush and then
baked in an oven - the wave only has bottom side preheat.  (I'm working on
reviving either the Hollis wave or the on-board foam fluxer, honest.)  Since
we are a low volume shop we might run the wave two or three days a week and
the remaining days it is turned off.  Is something wrong with the startup
routine?

The corrosion shows up around the pads of tin & gold plated connectors.  It
is one of those gremlins which appears and disappears without any apparent
pattern, just when you think it is gone . . .  bam!  The last analysis also
showed sulfur - don't know if that's an essential piece to the puzzle or
not.

We are checking to make sure the boards aren't corroded before soldering but
right now that's an assumption.  At least, a visual inspection doesn't show
anything obvious.

Anybody seen and defeated this Moriarty before?  We've not a moment to lose!

Hans


~~~~~~~~
Hans M. Hinners                                 WR-ALC/LYPME Bldg. 640
Materials Engineer                                      380 Second Street,
Suite 104
Manufacturing Eng. Sec.                         Robins AFB GA 31098-1638
912-926-1970 (Voice) 468 - 1970 (DSN)   912-926-7974 (Fax)
[log in to unmask]

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################