Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 5 Nov 1999 10:48:54 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Steve Gregory postulates:
>So I had a mix of two pin-1 positions, but there were more lower left
pin-1's
>than the other. By the way, how I referenced upper right and lower left
was
>by holding the tray so that the part numbers stamped on the parts were
>reading correctly in front of you.
Steve, I think if you check the JEDEC info, you'll find that the pin one
is always referenced to a feature in the tray, not the manufacturer
marking...
and IS consistant. I dont believe manufacturer marking of P/n or logo is at
all a
reference for anything!
Hope this helps!
John
(Wielding Component Engineering Magic) :-)
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|