Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 19 Nov 1999 15:32:43 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Thank you Bob,
I have tried to tell the guys to make interfaces better so we can get rid of gaskets, but at Ku extremly small burrs and voids will cause uwave leakage and reflections, and make some fraction of a dB in reading. So, we use Si'rings also, but the gasket I talk about is for making the MECHANICAL interface better, i.e. a perfect ID-to-ID, resulting in less reflections. An ordinary surveillance radar with lots of power is of course not that critical. You can afford loosing one or two Watts here and there.
Again, thanks for advice.
Ingemar Hernefjord
Ericsson Microwave Systems
It is not too unusual of a question.
We use a lot of C and Ku band waveguide. Most of our assemblies fit
nice and tight and we have been able to eliminate conductive gaskets
and use cheap silicone rings to keep out the moisture. The one
situation I know we have to use conductive gaskets is for a WRD580
flange. We buy the gasket from a company called Microwave Resources,
our cost is under $10. Another is SAS Industries.
Microwave Resources
Bob Garvey
770-441-9193
SAS Industries
Steve Steckis
516-727-1441
Good luck.
Jay Bosserman
MCL Inc.
Hi, an unusual question, but I see many radar guys are reading also in TechNet.
So, what sealing gaskets do you use for flange-to-flange sealing, electrically
as well as gas tightening? We tried Indium, works well, but the price is
immense. If the waveguide is ordinary Al with Nickel+Chromate, then what about
Tin gaskets? Atmosphere around is dry and you have that Nickel barrier. Copper
seems to be too hard. Any good idea?
Ingemar Hernefjord
Ericsson Microwave Systems
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|