On many boards we build we place small pins for test purposes, can't be
done in wave so we do them in smt. These guys consume a major portion of our
cycle time so we would like to place these with a dedicated machine. Our
current pick and place machine leaves half as many of these pins on the
floor than it places on the board. Does anyone know of a better system to
pick and place something like this? About 1 cm long with a nub 1 third the
way down.
Any comments would be apprciated.
Dave
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################