Guys,
We are currently using a EMI shield which is dual in nature i.e. perimeter
is connected like SMT and leads are soldered like PTH. This shield is being
hand placed onto the board before reflow where perimeter is getting
connected to the board while the leads are soldered when the board goes to
wave soldering process.

Our problem is that this part is getting tilted easily and to prevent that I
am looking for some kind of solution- Does anyone has tried out the kinked
leads to provide snap fit so that it won't tilt during the reflow operation.
Any other potential solution to stop the tilt besides some kind of weight.
Does anyone ordered die and formed the leads and resolved the tilt problem?

My part is 1.5" X 2.5" with .5" height. Leads are .5" apart.


re,
ken patel

______________________________________________________
Ken Patel                       Phone:  (408) 490-6804
1708 McCarthy Blvd.             Fax:    (408) 490-6859
Milpitas, CA 95035              Beeper: (888) 769-1808

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################