Ed,
.004" is achievable with LPI but not so easy, consistently with DFSM. I have
a question about the effectiveness of a 3 or 4 mil dam between pads. I am
told that the purpose here is to prevent solder bridges during assembly.
Will a 3 or 4 mil dam really prevent a solder bridge? Is the benefit
derived, if there is one, greater than the risk if you have some of these
dams lift and trap flux residue, or actually flake off during assembly? Just
curious!
Scott
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################