Morning All -

Got the following input from Chuck Hruby, which I greatly appreciate.  Any
other comments?

Have a good week -

Kelly
------------------( Forwarded letter 1 follows )---------------------
Date: Mon, 20 Sep 1999 09:30:39 -0400
To: kelly.schriver
From: [log in to unmask]
Subject: MIL-STD-100 vs ASME Y14.100





     Kelly,

     I'm just now looking into updating our specs.  I'm not a expert but
this is what I've seen so far.

     MIL-STD-100 (in the forward) states that Chap 600 was replaced by ASME
Y14.35M and
          Chap 700 was replaced by ASME Y14.14.34M.

     MIL-STD-100 Chap 200 was partially replaced with the following
exception:
          The SMD (standard microcircuit drawing) is done to level 3
documentation, vs
          the SCD (source control document in Y14.24) is done to level 2
documentation.

     As far as Printed Wiring Board and Assembly Drawings I have seen no
difference between the
          two spec's.  In fact if you use the IPC-D-325 was very helpful in
outlining the documentation
          of the Assembly Drawings, and it meets both MIL-STD-100 and ASME
Y14.100 specs.

     I'm still learning to ... Chuck Hruby

     P.S.  I am not a member of TechNet (some one in our office is) so if
you could forward this to the
          other members I would appreciate it.

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################