Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 8 Sep 1999 08:31:31 +0200 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We don't. Gilbert catalogues are hot stuff here. If you are a G-man, why not invent a X-band or higher receptacle for mounting directly on LTCC? Yes, I know you have the "fork" model for edge mounting, but we would like to drop them directly on the LTCC module, like other chip components. Should be for P-P of course, no handsoldering. We have asked you once, but then Kovar was too expensive at that time. We want them for a couple of dollars each./Ingemar
-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]]
Sent: den 7 september 1999 18:15
To: TechNet E-Mail Forum.; Ingemar Hernefjord (EMW)
Subject: Re: [TN] Need coax connector with tight tolerance in z
direction
You should also consider Gilbert Engineering. They make some of the best
connectors as far as tolerance and performance goes. Contact
[log in to unmask]; or at 800-528-5567 xt 396.
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|