Sounds like you could use one of those little circuit board prototyping
machines that are made by LPKF. (http://www.lpkf.de )
Ahne Oosterhof
A-Laser, Inc.
(503)641-9428
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Jon Moore
Sent: Friday, September 03, 1999 7:43 AM
To: [log in to unmask]
Subject: [TN] precision mini-drill-press
Does anyone know where I can get a mini (table-top) drill press with
precision location in XYZ? I used to have one for drilling out PTH in
multi-layer PCB's for design changes/verifications/prototypes. I would like
to have .001" accuracy in all three axes.
Jon Moore
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################