Experts,
We have couple of RF boards which are relatively new to us. Many times, we
have to replace passive components to make it work. Hence, I have this
hypothetical question for you. Is it due to not having correct impedance
value even though measured value on coupon falls within 50+/-10 ohms%? Do
you think we may to have tighten our current impedance specification
(50+/-10 ohms%) if there is a relationship?

Being a mechanical kind of guy this question may sound stupid! Hope to hear
from many of you.

re,
ken patel
______________________________________________________
Ken Patel                       Phone:  (408) 490-6804
1708 McCarthy Blvd.             Fax:    (408) 490-6859
Milpitas, CA 95035              Beeper: (888) 769-1808

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################