Hi, Technetter!
    We are designning mirowave PCB. so far we request the PCB supplier
to take 10% as each layer's tolerance of thickness for  finished
multi-layers microwave PCB. Does the tolerance properly? Is any good
suggestion?
  Thanks for any advice!
  Davis

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################