ANSI/J-STD-001 basically says that gold plated through hole and surface
mount components need to be cleaned by solder dipping or wave.
My question is, are there any guide lines for soldering wires to gold
plated pierced or perforated terminals (plating thickness is unknown).
These are typically very small (thin) and there is a wire going through the
hole that doubles back on its self. This is soldered with a goodly amount
of solder.
Any problem?
Ken Bloomquist
Sr. Principal Process Engineer
PRIMEX Aerospace Company
P.O. Box 97009
Redmond, WA 98073-9709
http://www.primextech.com
Ph: 425-885-5000
FAX: 425-882-5786
[log in to unmask]
Northcon/2000, Board Member
http://www.northcon.org
Electronics Manufacturers Association (EMA), Vice President
http://www.ema-wa.org
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################