Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 12 Aug 1999 06:35:00 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I agree with other respondents, feeling that three minutes at 235 will dull the fillet
and discolor the board.
The IPC-A-610B does not require solder flow on both sides of a PWB at sites with
machine inserted pins. I would not expect a solder fillet to form on lands of the
secondary side of the board in your application. 75% vertical fill is acceptable.
DEEPAK KURIYAN wrote:
> Hello Technetters,
>
> We are doing a job of soldering around 4500 pins into a Glass Epoxy
> Multilayer PCB of size 288 x 200 mm. The pins are first push fit into the
> PCB . The pins protrude on both sides of the PCB . On once side the pins
> will mate with a connector, and on the other side wires are wrapped on. 1
> Solder ring ( 0.9 mm dia ) is then put over each pin . The board is then put
> in a reflow over for 180 sec at 235 deg C. We find that the solder joint are
> not properly formed, and the finish is quite dull. The solder ring is
> composed of 62% Tin, 2 % Silver, 34 % Lead. The solder flows out to the
> other side of the PCB , but is not quite enough. We also notice
> discoloration of the PCB after this cycle.
>
> What are the issues that we need to be looking at here, to get a better
> joint with a better finish . We are completely new to this .
>
> Appreciate some inputs and tips on doing this
>
> With warm regards
>
> Deepak Kuriyan
> Framatome Connectors OEN
>
> ##############################################################
> TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
> ##############################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
> the body:
> To subscribe: SUBSCRIBE TECHNET <your full name>
> To unsubscribe: SIGNOFF TECHNET
> ##############################################################
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
> information.
> If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
> 847-509-9700 ext.5365
> ##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|