Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 2 Jun 1999 15:40:52 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Technetters,
Our design engineers are insisting on putting a wire for a current loop on
one of our boards.
Is their a faster, cheaper way to achieve the same result? This wire
assembly is going to slow down and make expensive a board which is currently
all surface mount.
Thanks in advance.
-Steve
Steven K. Lustig
Process Engineer
EMS Technologies, Inc.
Norcross, GA
(770) 263-9200 x4714
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|