Doug,
        Brady has the sleeves and the printing systems to do this, check
out:
http://www.bradyid.com/brady/isdwebv1.nsf/?Open

Mike McMonagle
PCA Process Engineering Supervisor
K*Tec Electronics
1111 Gillingham Lane
Sugar Land, TX  77478
(281) 243-5639 Phone
(281) 243-5539 Fax
[log in to unmask]

> -----Original Message-----
> From: Hooper Doug [SMTP:[log in to unmask]]
> Sent: Tuesday, June 22, 1999 7:04 AM
> To:   [log in to unmask]
> Subject:      [TN] Marking Sleeves
>
> I have a requirement to apply heat shrinkable "marking sleeves" to
> wires
> on my assembly. I have no experience with this process. Raychem is one
> supplier of these sleeves. Are there mfg.'s of the printer/software
> specifically for this process or can I use a typical pin printer? Is
> it
> better to buy a system or set-up my own system/software? What about
> the
> ink in the pin printer ribbon? My process requires me to mark tens of
> thousands of wires with their unique identification.
>
> Thank You!
>
> Douglas A. Hooper, Sr.
> Luminescent Systems, Inc.
> [log in to unmask]