Thanks to those that responded to my earlier question.  I have one more
question about the 04 X 05 chuck.  I was told that the 04 chuck is roughly
.3125" wide and the 05 chuck is .1875 wide(where it picks up the part).  It
has a compliant nozzle, and it's OD is .25" and ID is .125".  Does this
sound correct to you guys.  Thanks for your response.

Jim

-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]]
Sent: Tuesday, June 08, 1999 2:23 PM
To: TechNet E-Mail Forum.; West, Jim
Subject: Re: [TN] Quad 100




Jim,

I don't know what the "E" stands for but I have the same head for my 100.  I
use
it for everything from SOIC-8s to a .4x.6x.25" filter pack.   I've replace
the
bearings on the actuator and make periodic adjustments to the centering jaws
but
it seems to chug away for me.

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################