Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 15 Jun 1999 14:07:55 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Ed-
I believe that the "thru" means the threads should run the length of the
hole, rather than stopping short of the bottom. Please, anybody, correct me
if this is wrong.
-Ryan Jennens
TelGen Corporation
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of McGlaughlin, Jeffrey
A
Sent: Tuesday, June 15, 1999 1:57 PM
To: [log in to unmask]
Subject: Re: [TN] Fab: Tap and die callouts
Unified National Fine class 2B. You will need a Machinist Handbook to get
the class definition.
Jeffrey A. McGlaughlin
PCB Designer
Battelle Memorial Institute
Columbus Ohio
[log in to unmask]
-----Original Message-----
From: Ed Cosper [SMTP:[log in to unmask]]
Sent: Tuesday, 15 June, 1999 13:53
To: [log in to unmask]
Subject: [TN] Fab: Tap and die callouts
Hi all,
I hate to display my ignorance but I need to know what #10-32
UNF-2B thru means. I understand it is a treading requirement with a 10-32
tap but I dont know what "UNF-2b thru"means.
Thanks
Ed Cosper
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|