Ron,
Nailed!!! Once again my quick-and-dirty approach is exposed for what it is!
You're right, hand-held multimeter will show a continuous current rather
than an exponentially dropping one. With an appropriate series resistor
capacitor heating is eliminated. I'm just an engineer (not a QA type). Are
there standard incoming inspection tests for cap's? The problem of
mis-labeled tant caps is not at all rare. I know that most of my assemblers
do not test incoming parts. Perhaps they should. Is there a IPC or other
standard I can refer them to?
Ray
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################