I too read this but I don't recommend it. The amount and type of flux
in many pastes will 1. scum up your pot - it's quite messy and 2. be a
fire hazard. I've tried it and won't do it again. Go with your metal
reclaim. Small amounts are useful for tinning soldering irons.
>-----Original Message-----
>From: Sunil Gupta [SMTP:[log in to unmask]]
>Sent: Sunday, June 20, 1999 8:40 PM
>To: [log in to unmask]
>Subject: Re: [TN] Solder paste disposal
>
>The best way I presume of disposing the solder paste is by throwing the
>paste into the wave solder bath. This method was suggested in one of the
>reputed magazines, which I donot remember now.
>
>
>regards
>
>Sunil Gupta
>
>
>
>
>Garry Beaumont <[log in to unmask]> on 21-06-99 01:39:50
>
>Please respond to "TechNet E-Mail Forum." <[log in to unmask]>; Please respond
> to Garry Beaumont <[log in to unmask]>
>
>To: [log in to unmask]
>cc: (bcc: Sunil Gupta/TTL)
>Subject: [TN] Solder paste disposal
>
>
>
>
>Hi
>Can anyone offer advice on the disposal (environmentally friendly) of the
>empty solder paste tubes?
>Does anyone clean the empty tube of solder paste residue leaving just
>the disposal of the plastic? If you do, how do you do it safely? Do you
>then rely on evaporation to recover the solids?
>What advice can anyone offer on disposal of the solder paste solids?
>
>
>Also how is the industry handling the disposal of Nickel - cadmium
>batteries?
>
>Any info on the above would be appreciated.
>Thanks - Garry Beaumont
>Email:garry [log in to unmask]