Dear Mr. Jim West,

In my opinion the Protel v3.1 is good for simple layouts, but it is for Dos.
I am not sure if you are like it, you are familiar with it because
you have used Tango in the past and some one call it Tango Pro.

Regard,

Jin Hong
CPCA PCB Training Center

-----Original Message-----
发件人: West, Jim <[log in to unmask]>
收件人: [log in to unmask] <[log in to unmask]>
日期: 1999年5月26日 21:49
主题: [TN] PCB Layout Software


>Hello,
>
>I am looking for a low cost software that will do layouts for PCB's that
are
>low density.  I have tried what Electronic Work Bench offers, but was not
>happy with it.  I have recently seen in a magazine, a software called
>TraxMaker PCB layout(Ver 3.0) $279.00.  Also, There was a software called
>WinBOARD PCB layout.  $129.95.  I have used Tango in the past and I realize
>that the low cost versions do not stack up to that or any of the other
>$2000.00 + packages.  Has anyone used any of the low cost software that I
>have mentioned or does anyone know of any software that is $500.00 or less
>that is good for simple layouts.  Any suggestions will be greatly
>appreciated.
>
>Thanks,
>
>
>Jim West
>Manufacturing Engineer
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe:   SUBSCRIBE TechNet <your full name>
>To unsubscribe:   SIGNOFF TechNet
>################################################################
>Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
>For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
>################################################################
>
>

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################